Delphi SKYFi2 - XM Vehicle Kit Guide d'installation télécharger pdf (Page 3)

Figure 2. Connect accessories to your SKYFi Home Stand as shown.

5. After powering up, if the display reads

“ANTENNA,” check that the antenna con-

nection is secure and completely pushed

in. Next, change channels (from 0 to 1 or

from 1 to 0 if the receiver is not author-

ized yet). If the “ANTENNA” message

remains, power down the radio, unplug

the antenna, and look for any obvious

damage. If no damage is detected,

reconnect the antenna, turn the unit

back on, and change channels again.

If the message still appears, contact

your retailer.

1 2 3 4 5 6 7 8 ... 19 20

Pas de commentaire

Delphi SKYFi2 - XM Vehicle Kit Guide d'installation Page 3