Delphi SKYFi2 - XM Vehicle Kit Guide d'installation télécharger pdf (Page 12)

Removing car cradle mount from your

dashboard

You can remove the car cradle mount from

your dashboard by taking the following steps:

1. Lift one edge of the adhesive pad gently

with fingers or the rounded edge of a

spoon. Once enough of the edge is loos-

ened to grip with your fingers, pull the

pad gently from the mounting surface at

a 90-degree angle. Avoid using sharp

tools that could damage the car interior.

2. If the pad fails to loosen, first warm it

with a hair dryer for 2 minutes to 3 min-

utes to soften the adhesive. Be careful

not to apply too much heat, which could

damage the mounting surface.

3. If any adhesive remains on the dash-

board surface, the adhesive can easily

be removed by rubbing your thumb or

finger across it.

4. As necessary, apply a silicon coating,

such as Armor All

protectant, to the

dashboard surface in order to restore

its shine.

Caution: Never use a commercial heat gun or

paint-stripping gun. This could result in damage to the

unit or to your vehicle.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Delphi SKYFi2 - XM Vehicle Kit Guide d'installation Page 12