Delphi Portable Navigation Nav100 Spécifications télécharger pdf (Page 40)

Routes

Multi-Leg Routes

Multi-leg routes can be used to navigate to a final destination using multiple legs. An

example would be leaving the dock, motoring over to buoy 1, then the bait boat and finally to

a fishing hot spot. This route would go from Dock to Buoy 1,Buoy 1 to Bait, Bait to Fish.

Features of a multi-leg route:

• Multi-leg routes can be saved in memory. (A maximum of 20 routes can be saved. Each

saved route can have up to 29 legs in the route.)

• Multi-leg routes remain active even after the eXplorist has been turned off.

• Multi-leg routes can be edited, reversed, deleted or viewed on the plotter.

• When a multi-leg route is active, you can switch which leg will be used as the next

destination point. In the above example, you could skip going to Buoy 1 by selecting

the Bait leg when the route is active.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 75 76

Pas de commentaire

Delphi Portable Navigation Nav100 Spécifications Page 40