Delphi SkyFi SA10001 Spécifications télécharger pdf (Page 7)

4. Place the antenna so that the base is flush with the

back of the Audio System, and then slide down approxi-

mately 3/8ths of an inch so that the tab at the base of the

Audio System lines up with the slot in the bottom of the

antenna.

5. Position the antenna by pivoting the half with the XM

logo away from the back of the Audio System and turning

the entire Audio System until you get the strongest signal.

6. Use the “Antenna Aiming” screen as described in the

previous section to optimize the antenna tilt angle and

position.

If you are unable to receive a signal, then position the

antenna as described in one of the next two sections.

Indoor installation on a flat surface

To aim your antenna at the satellite:

1. Set antenna flat against its base on a flat (horizontal) surface.

2. Turn the base of the antenna so that the XM logo is

facing to the south.

3. Use the “Antenna Aiming” screen to optimize antenna

tilt angle and position.

4. If necessary, experiment with different locations near

a south-facing window or outside.

Your antenna comes with 20 feet of cable. If that is not

sufficient to locate the antenna where there is a strong

XM signal, purchase a 50-foot cable extension (Delphi

model number SA10006) from your SKYFi

retailer. Up

to eight extensions can be used together for up to 40 0

total feet of cable.

2. Fold the antenna down flat against its base.

3. Position the antenna so that the XM logo is upside down, then place the antenna base

against the back of the Audio System so that the four pegs line up with the four slots in the

antenna base.

Outdoor installation or indoor wall mounting

The antenna can also be attached vertically to an external or internal wall if that is more

convenient than placing it on a horizontal surface.

1. Holding your antenna up, find a wall location that ensures a strong signal. It is recom-

mended that you use an extension cord to temporarily locate your SKYFi

Home stand

outdoors while optimizing the antenna location with the “ Antenna Aiming” screen.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Delphi SkyFi SA10001 Spécifications Page 7